Settings for the Disaster Recovery System
[DisRec] switchingDriverActiveTimeout
- Type
- int
- Default
- 0
Time in seconds after a DRS switch-over (manually or automatically) which should be
waited before the driver connections will be activated on the active DRS system.
[DisRec] syncStatusBits
- Type
- bool
- Default
- 0
- Range
- 0|1
Defines whether the _online.._status bits are synchronized or not. 0 => status bits are
not synchronized 1 => status bits are synchronized
[DisRec] syncUserBits
- Type
- bool
- Default
- 0
- Range
- 0|1
Defines whether the _online.._userbits are synchronized or not. 0 => userbits are not
synchronized 1 => userbits are synchronized
[DisRec] useOfflineErrorstateInfo
- Type
- bool
- Default
- 0
- Range
- 0|1
If this entry is set to 1, the DRS stores the maximal current error state during a
network interruption between the systems. This system, which had the higher error state
during the interruption, becomes passive. If the MaxOffline error state of both systems is
the same, the current error state will be compared. If these equal, the system becomes
active, which was already the active one before the interruption.
