Why does the S7 driver not show the status "Connected" for a PLC connection?

To get the connection state 'Connected' for a new created device (via S7 device panel) at least one active peripheral address for this PLC has to be configured.
Configure the correct address and activate it afterwards. 
Start the driver again and check the connection state. Now the state should change to 'Connected' if all other parameters for this PLC are set correctly.

Date added:
Last revised:
Hits:
5.584
Version:
3.10, 3.11
Rating:
  • Current rating is 3.1 out of 5
Rating: 3.1. 58 vote(s).
58 anonymous votes No rating done at all.
Your vote was '' (0 of 5) You are an anonymous user.
You may log on to do personalized votings
 Click the rating bar to rate this item Please log on to do ratings

  • Notification

    FE user cannot be identified! (1403201096)

Tags:
PVSS, WinCC Open Architecture
 go back