The project ver is 3.15

Hi, The project was not stopped normally, the computer closed. When the project started again, the error occured and "Datamanager" not started. The occured error is below. How can I do to start project? WCCILdata (0), 2022.11.08 16:22:52.190, SYS, INFO, 0, , Initializing last value cache W...

Hi, We want to display total alerts count top of screen. How ca I get total came alerts count , gone alerts count and ack alerts count to display screen. This displayed values will be changed when came any alarm, gone any alarm or ack any alarm automatically. (This value don't change any button acti...

I want to get the list of dp elements defined in one dp group. We will use the dp elements defined in the dp group for sending email common message. The dp elements can be defined in this dp group by operator.
Control script always check this dp elements in the dp group

Hi,

How can I take list defined dp of the the DPgroups. Which function can be use for this issue?

Thank you

There are modbus drivers that before defined in standart project.
After changed standart project to redundancy project Is there any way automatically create modbus drivers for host 2?

Defined some modbus driver in standart project. When changed to redundancy project, have to create modbus driver(for example _Mod_Plc_3_2) for redundancy system manually?

or Can be defined to automatically creating in config.redu? How can be done this.

Thank you

Hi,

We are using WinCC OA 3.14. We have developed project as standart project. Now we have to change the standart project to redundancy project.
Is it possible.?
Is there any document for this issue?

<t>Hi,<br/> <br/> When alerts filtered as closed in time range (for instance last 24 hours), The error is occurred "Too much data in specified time range or syntax error in filter!"<br/> <br/> We are increase maxLinesInQuery parameter on [data] section. But result is same.<br/> <br/> How can I find ...

Hi,

We are using value over time trend. And we created 3 curves. I see that 3 values created on y axis for 3 curves. How can I set common values Y axis for all curves. Is it possible. All curves will be link same Y (values axis).

Thank you