NTCIP Gateway Debug Flags

This chapter describes possible debug levels for the NTCIP gateway.

NTCIPLoggerFlags

The NTCIPGW Logger Flags define the logging details for the NTCIP communication library. Usually, they can be set to 0, which means no logging/tracing at all. However, during commissioning or testing, it is recommended to use these flags to get some insight into the NTCIP communication process. The flags are representing a bitmap pattern, therefore multiple flags can be activated by just adding the flag values given in the following table. The default setting is 0, which means that by default no flags are activated.

To activate the NTCIPGW Logger Flags the config entry [ntcipgw] NTCIPLoggerFlags must be used.

Note:
The config file is read only during startup. Any changes in the config file are only available after restarting the NTCIP gateway manager.