Is it possible to trigger function recalculation/synchronization event from CTRL?
I need to read a Daily Total value right after my technology process completion, but "Floating Calculation" + "Part Interval" only allow 12 intervals.
And "Save intermediate results" does not seam to do anything.
Statistical function: Total calculation
- leoknipp
- Posts:2928
- Joined: Tue Aug 24, 2010 7:28 pm
Re: Statistical function: Total calculation
A recalculation of a statistical function can be triggered by writing a correction value for one of the input parameters for the given period.
E.g. if you want to recalculate a daily values based on hourly values you have to set one of the hourly values again as correction value. You can also write the same value again.
Best Regards
Leopold Knipp
Senior Support Specialist
E.g. if you want to recalculate a daily values based on hourly values you have to set one of the hourly values again as correction value. You can also write the same value again.
Best Regards
Leopold Knipp
Senior Support Specialist