new user, Question S7-Driver added but then ?

[PeterGold]

I have received a demo Wincc OA, and did some testing with the demo.

Now i have tried to setup a new test config.
I added the S7 driver to ceoonect a s7-300 with CP343-1 lean, take my plc settings ip adress , rack slot imported all the tags from the S7 project.

But now what todo now?

I can not find anything in the datapoint parameterzion

Or does the s7 driver not run in demo mode ?

Also i tried recipie but also needs a licence in demo ?

I found some nice starting video's on youtube : https://www.youtube.com/channel/UCGBnHd ... MDsjTk0-Sw However it stops at lesson 05

[RudiKreiner]

In the ETM Porta at portal.etm.at, in the download page, under events WinCC OA User Days London there is a very good presentation called "Workshop - WinCC OA User Days 2016 Communication Drivers Protocols" that describes how to use various drivers, among them the S7 drive. That should help some, at least.

[Gertjan van Schijndel]

In general there are the following steps for setting up communication to a device:
1. Configure device
2. Configure poll/subscription group
3. Configure a periphery address