Different drivers for different DP`s with the same master point

[amenoyo]

Hi I hope someone can help me with this doubt, because I can`t find anything in the online help.

I have one master point, where I configure the periphery adress of the tags, but the problem is that I have two DP`s (one with Siemens and the other one with Schneider) and in the master point is impossible to configure two different drivers, I have seen the free adress config but I can`t find how to configure it.

When I go to the DP to configure the free address I find these fields:

Address active [b0/1]

Periphery Address [s]

Subindex [0..1023]

Address mode [1..5]

I don`t know if ithis is the correct way of communicating two DP`s with different drivers or if I have to do it in a different way.