I've been asked to look at the possibility of using PROFIsafe to communicate between WinCC OA 3.16 and a S7 1500 F series PLC
Is this possible?
If so Is there a driver for WinCC OA to do this or some other means.
Thank you
PROFIsafe between WinCC OA and S7 1500
- leoknipp
- Posts:2928
- Joined: Tue Aug 24, 2010 7:28 pm
Re: PROFIsafe between WinCC OA and S7 1500
We are currently working on an own driver for PROFIsafe and PROFInet. It will be available with one of the next patches for WinCC OA 3.16.
Further information for the prerequisites (e.g. usage of a specific network interface) will then be available in the documentation delivered with the patch.
Best Regards
Leopold Knipp
Senior Support Specialist
Further information for the prerequisites (e.g. usage of a specific network interface) will then be available in the documentation delivered with the patch.
Best Regards
Leopold Knipp
Senior Support Specialist
- kumar.samarth@tcs.com
- Posts:7
- Joined: Wed Jul 10, 2019 6:45 am
Re: PROFIsafe between WinCC OA and S7 1500
Hi Can you mention that the update is released or notleoknipp wrote: ↑ Wed Mar 27, 2019 12:26 pm We are currently working on an own driver for PROFIsafe and PROFInet. It will be available with one of the next patches for WinCC OA 3.16.
Further information for the prerequisites (e.g. usage of a specific network interface) will then be available in the documentation delivered with the patch.
Best Regards
Leopold Knipp
Senior Support Specialist
- leoknipp
- Posts:2928
- Joined: Tue Aug 24, 2010 7:28 pm
Re: PROFIsafe between WinCC OA and S7 1500
Since patch 3.16 P009 the new PROFIsafe-over-PROFINET driver is part of WinCC OA.
For details please install the newest patch for WinCC OA 3.16 and have a look at the documentation.
Best Regards
Leopold Knipp
Senior Support Specialist
For details please install the newest patch for WinCC OA 3.16 and have a look at the documentation.
Best Regards
Leopold Knipp
Senior Support Specialist