WARNING that occurs when the $ parameter value is not entered

Find and share HowTos to various installations / configurations!
Search

Post Reply
2 posts • Page 1 of 1
SMT_SOL
Posts: 20
Joined: Fri Feb 07, 2020 1:04 am

WARNING that occurs when the $ parameter value is not entered

Post by SMT_SOL » Tue Jun 23, 2020 8:24 am

The symbol is using $-parameter.
For example, symbols in use from $DP1 to $DP10,
but if you enter only the values ​​from $DP1 to 5, a warning appears that there is no value from $DP6 to 10.
-> Parameter incorrect, did not find the $-parameter,<-
Since there are many symbols, it is difficult to enter all blank values. Is there a workaround for this in scripts?

mkerk
Posts: 66
Joined: Wed Oct 20, 2010 10:25 am

Re: WARNING that occurs when the $ parameter value is not entered

Post by mkerk » Tue Jun 23, 2020 12:32 pm

Hi,
all $-parameters must have a valid value (an empty string a $-parameters is also OK ) , otherwise you the error message "Parameter incorrect ..." will be written to the logViewer.
You can in your symbol, define default values for the $-parameters and check if these are valid in the script of the references. default values can be set in the GEDI, when adding the reference in the panel ( via the standard or an own created configuration panels for this reference), or in runtime when opening the panel-reference using for example RootPanelOn, ChildPanelON, addSymbols...

BR,
Mousser.

Post Reply
2 posts • Page 1 of 1