Panel crash, after inserting AESRow ref. panel

Discussions about product bugs & problems!
Note: This is no replacement for the Official ETM Support!
Search

Post Reply
2 posts • Page 1 of 1
pepo6121992
Posts: 5
Joined: Thu Aug 17, 2017 12:01 pm

Panel crash, after inserting AESRow ref. panel

Post by pepo6121992 » Mon Sep 09, 2019 9:02 am

Hello,

After adding AESRow.pnl to the panel and setting the dollar parameter ($SCREENTYPE) with non existing configuration, the panel will crush after opening him in the runtime and without any log message. Same behaviour apply on the AEScreen.pnl .
Is there any solution or workaround to stop this behaviour? Except the obvious one to create the configuration.

WinccOA 3.15 P020

Thanks.

mplatz
Posts: 5
Joined: Mon Oct 29, 2018 8:00 am

Re: Panel crash, after inserting AESRow ref. panel

Post by mplatz » Mon Sep 09, 2019 11:29 am

Dear Customer,

Forwarded the behaviour to our development.

Currently there is no workaround - only to create a new configuration or use an existing one (e.g. "aes_default")

kr,
Platzer Matthias

Post Reply
2 posts • Page 1 of 1