WinCC_OA S7Plus Driver
Note: This is no replacement for the Official ETM Support!
I'm using WinCC_OA 3.15 and I need to use S7 Plus Drive to communicate with TIA PORTAL V15 (PLC:S7-1500), so the communication type is not TSPP, but Pooling and subscriptions.
But when I install "SIMATICSCADA_Exporter" and I use the command "Export to SIMCATIC SCADA" of TIA Portal V15, it doesn't work and suddenly the program shutdowns.
How can I make the connection between WinCC_OA and TIA PORTAL V15 using S7+ Driver with S7-1500?
So if alarm synchronization is not needed, try it with online browsing. Otherwise upgrade TIA Portal (and SIMATIC SCADA exporter) to V15 SP1.
In this official website there is only V15 and V15_1
https://support.industry.siemens.com/cs ... 0&lc=en-CZ
How can I configure the online browsing?
Thank you so much
I have WinCCOA 3.16 and I can make the communication and the importation of the symbols but my client wants WinCCOA 3.15....