SIMATIC WinCC Open Architecture Forum

Hi,
In my project, OA have to send the data to Modbus TCP Client.
When I configure the Modbus element setting in plant model edit.
The setting components of the define transformation is not shown.
I tested two program versions for the same problem. The 3.15 version is no problem. but, 3.16 P12 version is problem.
Please check and feedback to me.
Thanks.

I have seen that you have also submitted an service request in the Siemens Industry Portal. Please wait for the reply from the support team.
In the future please do not ask the same questions in different places and take into account that the WinCC OA Portal is not a replacement for the WinCC OA support.

Best Regards
Leopold Knipp
Senior Support Specialist

I got the information that my colleague has forwarded this issue to our development team.
They will have a look at it.

Best Regards
Leopold Knipp
Senior Support Specialist