SIMATIC WinCC Open Architecture Forum

Posted: **Thu May 16, 2019 8:11 pm**

Hi community,

When project start-up I've got the following log-message twice:

WCCILevent   (0), 2019.05.14 07:32:58.748, IMPL, SEVERE,     54, Unexpected state, DpMsgIdentification, operator<<, No Identification

Does anybody know whether it could be ignored, never seen that before.

3.14, p22, Redu with Dist-connections

Posted: **Fri May 24, 2019 4:42 pm**

Only with the single line for the log entries we cannot see when at startup the problem occured and if there are written other errors before or after this message.
For the analysis we need more information, e.g. the complete PVSS_II.log file.
Please get in contact with your common WinCC OA support.

Best Regards
Leopold Knipp
Senior Support Specialist

Posted: **Mon May 27, 2019 10:48 am**

I just have seen that the same topic was submitted as a service request and was send to the WinCC OA support.
To get the current status please get in contact with your colleagues.

Best Regards
Leopold Knipp
Senior Support Specialist

SIMATIC WinCC Open Architecture Forum

DpMsgIdentification, operator<<, No Identification

DpMsgIdentification, operator<<, No Identification

Re: DpMsgIdentification, operator<<, No Identification

Re: DpMsgIdentification, operator<<, No Identification