Message conversion Counter pulses

Find and share HowTos to various installations / configurations!
Search

Post Reply
2 posts • Page 1 of 1
JukkaP
Posts: 1
Joined: Mon Mar 23, 2020 1:32 pm

Message conversion Counter pulses

Post by JukkaP »

Hi,

I would like to calculate rising edges of a trigger bit.

In Para, I made a config "Message conversion" for the trigger bit DPE (type bool) and selected Counter pulses with property "Change 0-> 1".

My question is, how can I read the counter value (result) into another DPE (type int).

User avatar
leoknipp
Posts: 2645
Joined: Tue Aug 24, 2010 7:28 pm

Re: Message conversion Counter pulses

Post by leoknipp »

The message conversion _msg_conv can only be used for a DP element which receives values from a peripheral device as the driver is using this config.
If a value is received from the device the driver does the calculation defined in the config and writes the result to the original value.

Best Regards
Leopold Knipp
Senior Support Specialist

Post Reply
2 posts • Page 1 of 1