AES Table configuration

Discussions about product bugs & problems!
Note: This is no replacement for the Official ETM Support!
Search

Post Reply
2 posts • Page 1 of 1
Eksergian
Posts: 4
Joined: Tue Sep 18, 2018 8:32 am

AES Table configuration

Post by Eksergian » Tue Aug 13, 2019 11:06 am

Hello there,

I want my alert table (AEScreen) to be capable of displaying a certain panel when an alert is clicked. The panel will depend of the related datapoint.
To do so, I've noticed that in the "Column Configuration" I could assign an "OnClick" function, such "displayDetail" and "userDefFunc".

I would like to use the "userDefFunc", so I've saved in my project the aesuser.ctl file with the "invokedAESUserFunc", but each time I click on the table, the debug outputs that the column = 0, except for a certain column (acknowledgement) which outputs its actual column.

Do you know why this happens? There could be a previous configuration I do not about, so could something be blocked or protected?

Thank you in advance.

User avatar
leoknipp
Posts: 2020
Joined: Tue Aug 24, 2010 5:28 pm

Re: AES Table configuration

Post by leoknipp » Wed Aug 14, 2019 9:08 am

In the AEScreen there is a standard function available to show a panel related to an _alert_hdl config.
Which panel shall be shown you can configure at the _alert_hdl config.

There is no need to implement an own functionality.

Best Regards
Leopold Knipp
Senior Support Specialist

Post Reply
2 posts • Page 1 of 1