DpMsgIdentification, operator<<, No Identification

Discussions about product bugs & problems!
Note: This is no replacement for the Official ETM Support!
Search

Post Reply
3 posts • Page 1 of 1
Piterskiy
Posts: 39
Joined: Wed Jul 09, 2014 10:44 am

DpMsgIdentification, operator<<, No Identification

Post by Piterskiy » Thu May 16, 2019 6:11 pm

Hi community,

When project start-up I've got the following log-message twice:

Code: Select all

WCCILevent   (0), 2019.05.14 07:32:58.748, IMPL, SEVERE,     54, Unexpected state, DpMsgIdentification, operator<<, No Identification
Does anybody know whether it could be ignored, never seen that before.

3.14, p22, Redu with Dist-connections

User avatar
leoknipp
Posts: 1819
Joined: Tue Aug 24, 2010 5:28 pm

Re: DpMsgIdentification, operator<<, No Identification

Post by leoknipp » Fri May 24, 2019 2:42 pm

Only with the single line for the log entries we cannot see when at startup the problem occured and if there are written other errors before or after this message.
For the analysis we need more information, e.g. the complete PVSS_II.log file.
Please get in contact with your common WinCC OA support.

Best Regards
Leopold Knipp
Senior Support Specialist

User avatar
leoknipp
Posts: 1819
Joined: Tue Aug 24, 2010 5:28 pm

Re: DpMsgIdentification, operator<<, No Identification

Post by leoknipp » Mon May 27, 2019 8:48 am

I just have seen that the same topic was submitted as a service request and was send to the WinCC OA support.
To get the current status please get in contact with your colleagues.

Best Regards
Leopold Knipp
Senior Support Specialist

Post Reply
3 posts • Page 1 of 1