Page 1 of 1

Ethernet/IP Driver can communicate with Allen Bradley GuardLogix type PLC?

Posted: Thu Jan 16, 2020 8:46 am
by deepankar.chakraborty@ltts.com
In WinCC OA 3.16, Ethernet/IP Driver does not support GuardLogix PLC type but can driver still communicate with this type of PLC by some alternate way?

Re: Ethernet/IP Driver can communicate with Allen Bradley GuardLogix type PLC?

Posted: Thu Jan 16, 2020 2:42 pm
by leoknipp
At the information for the GuardPLC I have seen that a OPC server is available.
If our Ethernet IP driver does not support this type of PLC you can use a OPC communication.

Best Regards
Leopold Knipp
Senior Support Specialist